Index / 339

339

339 — silver oxide, 1.55 V, 6.8 x 1.4 mm. Not listed by Energizer. The closest it still lists: 321 drops straight in, and runs the same 1.55 V.

What fits the compartment, and what does not

Fit answers whether it enters the compartment. Voltage answers whether the circuit will notice. A cell that fits is not always a safe substitute.

One cell matches on both counts: 321 is the same size and the same 1.55 V. The rest of the table trades depth for availability.

Unlisted, but something drops straight in

339 has left the Energizer catalog, but the swap is easy: 321 is the same 6.8 x 1.4 mm and runs at 1.55 V against this cell's 1.55 V. It holds about 20 milliwatt-hours, 13 mAh at 1.55 V. Internal impedance runs 35 to 45 ohms, which is what decides whether it can drive a pulse.

What a watch movement does with this cell

A quartz movement pulls a short pulse through the cell every second and reads the voltage between pulses. That is why the chemistry in this envelope matters more than the size does. Silver oxide holds 1.55 V nearly flat until it is spent.

Internal impedance 35 to 45 ohms, published by the maker. That is the figure the stepper motor pulse sees, and it rises as the cell ages. Energizer no longer lists 339, so the cell in the case of an older watch may have no current part under this designation at all. 3 cells measure close enough to compare against it in the Energizer data this site reads, and 3 of them are still listed.

• The nearest is 321: it drops straight in and runs 1.55 V, same volts.
• Energizer files it for North America, which is where the part is sold rather than where the cell will work.
• Energizer no longer lists 339 at all, so whatever goes into that compartment next will be a substitution rather than a replacement.

Drawn to scale

Every published figure

Every field the maker fills is filled for this one: 11 figures in all, from chemistry through to where it is sold.

2 rows in the table are not the maker's but ours: stored energy and energy per cubic centimeter. Everything else is reproduced without change.

The number a pulse sees

Energizer publishes an impedance band of 35 to 45 ohms for 339. It is the least quoted number on the sheet and the one that decides whether the cell can drive a pulse; 3 other published figures sit below.

The part occupies 0.053 cubic centimeters and weighs 0.2 g. Capacity and voltage together put 20 milliwatt-hours in that space. Energizer files it for North America.

Internal impedance

35 to 45 ohms as published. A high-impedance cell sags under a pulse and recovers between pulses, which is what a movement or a sensor sees.

Cutoff voltage

1.2 V. The published capacity is counted down to this voltage; a device that quits higher up sees less than the whole figure.

Mass against volume

0.2 g filling 0.053 cubic centimeters. When the printing has worn off, a kitchen scale separates two cells of one envelope faster than a caliper does.

Where the part is filed

North America. That is a statement about the maker's distribution and not about where the cell works.

Is that a lot of energy?

Nothing else measured shares this shell, so the comparison has to go site-wide: 20 milliwatt-hours in 0.1 cubic centimeters is 380 mWh per cc, denser than 56% of every cell measured here. Density is ours: the maker publishes capacity and volume and never divides one by the other.

A width the catalog keeps returning to

6.8 mm is a width this catalog keeps coming back to: 5 coins sit within half a millimeter of it, 339 included.

3 of those ones are still listed. Its 380 milliwatt-hours per cubic centimeter sit above 56 percent of everything here that publishes both a capacity and a volume. 32 of the 82 coins share its 1.55 V exactly.

• PR63 — the next step down by volume: 0.05 cubic centimeters against this cell's 0.053.
• 1191SO — the next step up: 0.06 cubic centimeters, 113% of this one.
• SR60 — 6.8 x 2.2 mm, 1.55 V, silver oxide.
• SR66 — 6.8 x 2.6 mm, 1.55 V, silver oxide.

Nothing else is stamped on this one

Nothing else is printed on 339 in the Energizer data this site reads: one designation, no trade marking, no maker's part number, and no long form in the standard's table. A cell measuring 6.8 x 1.4 mm carries its whole identity in 3 characters.

The cell that differs only in depth

The code says the size, so the cells that get confused with 339 are the ones that keep its diameter and change its depth. 3 cells share this diameter at depths from 2.1 to 2.6 mm, and every one of them enters the same opening.

It stands 1 of 1 in this envelope by stored energy. On a scale the difference shows before it shows on a caliper: this one weighs 0.2 g.

• 164 — same diameter, 2.1 mm tall against this cell's 1.4: 0.7 mm deeper, which neither designation carries.
• SR60 — same diameter, 2.2 mm tall against this cell's 1.4: 0.8 mm deeper, which neither designation carries.
• SR66 — same diameter, 2.6 mm tall against this cell's 1.4: 1.2 mm deeper, which neither designation carries.
• 1191SO — 5.8 mm across at 1.55 V against 6.8 mm here, 1 mm apart: loose in this holder.
• 317 — 5.8 mm across at 1.55 V against 6.8 mm here, 1 mm apart: loose in this holder.

One figure the maker does not publish

One field is empty for 339: operating temperature. A blank means the maker publishes no figure, which is not the same as zero, and it is the reason one comparison below is missing rather than wrong.

The blanks are the same in all 1 record behind this designation, so they are the catalog's silence and not a merge losing a value. What is not missing is the envelope: 6.8 x 1.4 mm, published and checked against the designation itself.

• No operating temperature — so this page cannot tell you whether the maker claims anything at all below freezing.

Before you swap anything

Everything here is computed from published dimensions and nominal voltages. That answers whether a cell enters the compartment and whether the voltage matches on paper. It does not answer what your device does with the difference, and it cannot: a cell that fits can still be the wrong cell.

One more limit, and it is the biggest. This site reads a single manufacturer’s catalog. When a page says a designation is not listed, that means Energizer no longer offers a part under it — not that nobody makes the cell. Other makers may still sell it, and for common sizes they usually do.

A voltage difference is one relation between two cells, and this page prints it from the cell it is about — in every table on the page, including the one listing cells no longer made. A figure always belongs to the cell whose voltage is printed beside it: a cell that runs lower than this one carries a minus here, one that runs higher carries a plus, and two cells at the same nominal voltage carry zero. Meet the same pair on the other cell’s page and the sign is the other one, with the figure taken against that cell instead of this one; where the two run at the same voltage, both pages print zero. The class beside the figure is not read off that figure directly. It is decided on the gap itself, taken against the higher of the two nominal voltages, so one pair of cells gets one class whichever page you meet it on: counted from this side the boundary of the class that still runs falls at 20.0% below and 25.0% above, which is the same gap divided once by the larger nominal and once by the smaller. What genuinely differs between the two directions is the consequence, and the words carry it: a cell that runs low makes a calibrated instrument read below true, and a cell that runs high makes it read above.

3 things this site cannot see. Whether the contacts reach a shorter cell. Whether the device was calibrated for a chemistry that holds its voltage flat, which silver oxide does and alkaline does not. Whether the equipment tolerates the higher current a different chemistry can deliver. Rechargeable cells are never a drop-in for primary cells regardless of size.

Cells measured next to this one

Nothing in the Energizer data on this site shares this exact size. The 3 cells below have the same diameter and a different depth — 2.1 to 2.6 mm against this cell's 1.4 — which is a near miss rather than an alternative.

• 164 — 6.8 x 2.1 mm, 1.4 V
• SR60 — 6.8 x 2.2 mm, 1.55 V
• SR66 — 6.8 x 2.6 mm, 1.55 V

Where these numbers come from

Dimensions, voltages, chemistries and capacities are published by the manufacturer and reproduced without change. Everything else on the page is ours, computed from those figures: whether one cell fits where another sat, how far apart their voltages are, stored energy and energy per cubic centimeter, the rank within a shell, and the check of the designation against the measured size.

Fit is decided within 0.3 mm on every axis, which is the order of a contact spring's travel. Voltage classes are decided by consequence, not by roundness, and they are decided on the gap between two nominal voltages taken against the higher of the two: 2.0% or less of it is the same working voltage, 6.0% starts to matter to a calibrated instrument, and past 20.0% it is a different class altogether. Measuring the gap against the higher figure is what makes the verdict the same from either cell’s page, while the printed percentage stays counted from the cell you are reading about. Cells with identical stored energy share a rank instead of being ordered arbitrarily.

Ranking uses capacity times nominal voltage, because capacity alone is not comparable across chemistries: 150 mAh at 3 V is twice the energy of 150 mAh at 1.5 V. Neighbors are chosen by measurement and never alphabetically, because two cells filed next to each other by name usually have nothing in common. A blank in any table means the maker publishes no figure, which is not the same as zero.

Source: Energizer technical data, retrieved 1 September 2026.

The record behind this page

Every figure on this page comes from one catalog record, number 481, and it is linked below. The sheet is the document the dimensions, voltage and capacity were read out of.

1. [1] Energizer catalog record 481, obsolete in the snapshot. Technical data sheet: 339.pdf.

Every figure above is reproduced from those records without change; the comparisons are ours and are described on the method page. Snapshot: Energizer technical data, retrieved 1 September 2026.

Putting this on a forum or a repair page? The same answer without the site around it — fit, voltage, chemistry and the limits that go with them — is at /embed/339/. It loads nothing from anywhere else. Paste this:

<iframe src="https://batterycross.com/embed/339/" width="100%" height="520" loading="lazy" title="339 replacements"></iframe>